Q1:Is the Longmada Motar 1 mouthpiece, coil, or atomizer compatible with the Yocan Orbit?
A1:The mouthpiece, coil, and atomizer of the Longmada Motar 1 can be used with the Yocan Orbit. However, it's important to ensure that the temperature is not set too high to avoid any potential issues. The motar1 coil is suitable for 20-25w.
Q2:What is the difference between the Motar1 and Motar2 atomizers
A1：he difference lies in the glass pipe.
Q3:Are motar1atomizer and motar3 atomizer compatible?
A3: No, the Motar1 and Motar3 atomizers are not compatible because their glass mouthpieces and coils are different sizes. The Motar1 works better with the Trunk battery, while the Motar3 is best used with the Motar3 battery.
Q4:What is the most suitable wattage for the Motar1?
A4:It's recommended to use it at 20-25W. Using a higher wattage can damage the coil.
Q5: Will the Longmada Motar 1 and 2 atomizers work with the Motar 3 battery?
A5:Yes, the Longmada Motar 1 and 2 atomizers can work with the Motar 3 battery, but they perform better with the Trunk battery.
The Motar 3 is a temperature-controlled battery, but it needs to be used with an atomizer that has a temperature-controlled heating wire to effectively achieve temperature control.
Q6:Why the glass pot to be distorted.
A6:Please avoid touching or cleaning the glass pot when it's at high temperatures. Forceful contact can cause the glass pot to become misaligned.
Q7:The motar 1 what’s the target temperature range of using temp control
A7:Keep the temperature below 450 degrees Celsius and avoid using it more than 4 times in a row. Continuous use will raise the temperature. It is recommended to wait 2 minutes before using it again after 3 consecutive uses to extend the lifespan of the coil.
Q8:Why the vape said “check atomizer” and then stopped working.
A8:Check the atomizer; you may need to do this:
- Reinstall your atomizer and coil to ensure the atomizer is functioning properly.
- If the core is burnt out, replace it with a new one.
Because the power of the battery boxes varies, if the coil is not used with our batteries, it is recommended to start at the lowest temperature and gradually increase it. If the temperature is set too high right away, it could easily burn out the coil.
